[. . . ] MX-SD Please read this booklet as well as the ELECTRIBE· MX Owner’s Manual for information on using the new ELECTRIBE· mX-SD. This booklet describes features that are new or modified relative to those from the ELECTRIBE· mX. [. . . ] Before using an SD card on the ELECTRIBE∙MX-SD, please note the following: • In the sections describing SmartMedia™ in the Owner’s Manual, please replace “SmartMedia™” instances with “SD card. € • Please replace the “Using SmartMedia™” section on page 76 with the following section. Using an SD card You can use an SD card to save or load ELECTRIBE∙MX-SD internal data. The ELECTRIBE∙MX-SD supports SD cards of up to 2GB capacity and SDHC cards of up to 32GB capacity. The ELECTRIBE∙MX-SD may take time to recognize or write files on large capacity cards. new patterns • The Pattern name list on page 90 has been changed. New AC power adapter The AC/AC power supply has been replaced with an AC adapter. Due to this change, the AC 9V jack on the rear panel has been modified. Please refer to the following illustration for the location of the power adapter jack and the power switch, instead of the figure on page 14. About SD card write-protection To prevent data saved on an SD card from being erased or overwritten accidentally, set the write-protect switch to the “protect” position. If the card is write-protected, you will not be able to write to or erase data from the card, or format the card. If you want to save data to the card, you must move the switch back to the original position. [. . . ] Properly qualified service is not available for this product if purchased elsewhere. Any unauthorised modification or removal of original serial number will disqualify this product from warranty protection. [. . . ]